/In the present day’s House owner Radio Present Podcast| June 10, 2023
Today’s Homeowner Radio Show Podcast| June 10, 2023

In the present day’s House owner Radio Present Podcast| June 10, 2023

[ad_1]

This image is a split image. tHe photo on the left is of a screw being crewed into a wall with a screwdriver. The right photo is a garbage disposal.
Learn to stop drywall nails from coming out and what ought to and shouldn’t be put down a rubbish disposal. (3 Echoes Content material Studio)

Hour 1

Hear to listen to methods to stop nails from pooping out, elevate an outside dryer vent’s peak, and extra!


Tips on how to Cease Drywall Nails from Popping Out

This image is of someone screwing a screw into a wall with a screwdriver.
Use a drywall screw as an alternative of a nail to cease nails from backing out. ( 3 Echoes Content material Studio)

A home-owner’s home was in-built 1954 and she or he is uninterested in watching nails again out of the drywall.

She asks, “How do I repair this? Can I pound the nails again in?”

First, pounding the nails again in is only a short-term repair — they’ll finally come out once more. However the larger query is that this: why does it occur?

In a house, there may be quite a lot of motion — doorways slamming, folks strolling, and many others. All these actions trigger vibrations. And, over time, these vibrations will trigger a drywall nail to again out.

To repair this drawback, you’ll have to take away the nails and exchange them with screws as a result of drywall screws are the higher choice.

You don’t wish to simply take away the nail and exchange it with a screw earlier than checking if the nail is within the heart of the stud or near the middle. The stud could be the rationale it’s coming out.

So, we suggest taking a hammer and a ending nail and tapping by means of the drywall till you discover the middle of the stud.

As soon as you discover the middle and pull out the nail, then drive one or two drywall screws an inch or two above the previous nail gap. This may maintain it tight.

After changing the nail with a drywall screw, put joint compound over the screw heads and within the previous nail gap, let it dry, sand it, and do it once more. After you have it stuffed and sanded dry, paint it.

The screws will maintain up very effectively, and you’ll hopefully by no means have to do that course of once more!

Watch: Tips on how to Change a Drywall Nail


Tips on how to Elevate an Out of doors Dryer Vent

This image is of an outdoor dryer vent.
An out of doors dryer vent ought to be at the least 12 inches from the bottom. (3 Echoes Content material Studio)

A home-owner’s dryer vent runs on an exterior wall and underneath the brick veneer. It’s put in about an inch off the bottom as an alternative of 12 or extra (the advice).

He has hassle with stormwater entering into the vent, and now asks, “Do you will have any suggestions for me?”

First, it’s uncommon to discover a dryer vent so low to the bottom. It’s doable that when the vent was initially put in, it was the proper peak off the bottom. Nonetheless, as time handed, grading and landscaping might have been added, and the vent bought nearer to the bottom.

To make this dryer vent work effectively, you’ll wish to have as in need of a path as doable. So, we don’t suggest rerouting the present ductwork and going by means of the soffit.

As a substitute, we suggest attempting to raise or lengthen the prevailing vent upward, or digging grime across the vent to offer it more room. You might additionally add a slight flip and elbow to get it off the bottom.

Examine your native residence heart for a tool that curls up at 90 levels, which can assist elevate the vent on the skin. There are lots of dryer vent choices.

For security, don’t use PVC pipe for an elbow as a result of it can’t deal with the excessive temperatures that come by means of a dryer vent.

As well as, be sure to steadily clear your dryer vent to forestall home fires and hold your dryer working effectively.


Hour 2

Take heed to study rubbish disposal guidelines, methods to repair a rest room that received’t flush, methods to lay an underlayment over a tile flooring, and extra!


What You Can Put Down a Rubbish Disposal

This image is a below the sink image of a garbage disposal.
It’s acceptable to place issues down a rubbish disposal if they’re sufficiently small. (3 Echoes Content material Studio)

A home-owner and his spouse have had an ongoing disagreement about whether or not it’s okay to place scraps of meat down the rubbish disposal. They’ve septic tank disposal.

He says, “Can you agree this debate?”

It’s completely positive to have a rubbish disposal with a septic tank. Nonetheless, some septic tanks are actually good, and others are very marginal. That performs a big half within the disposal’s performance and what waste it accepts.

So, what may be put down a rubbish disposal?

In relation to rubbish disposals, you do wish to use them sparingly and never put all the pieces down it. You wish to keep away from placing massive substances down.

The reply to the query could be sure, however solely small items of meat, and don’t pack it full.

Ensure you use and keep rubbish disposals appropriately. It is strongly recommended to make use of chilly water to clean waste down the drain and make sure you don’t put one thing within the rubbish disposal and never run it!

In case your rubbish disposal will get clogged, use this trick!


Tips on how to Remedy Bathroom Flushing Points

This image shows the inside of a toilet, specifically focusing on the chain and flapper.
Adjusting the chain is a simple repair to resolve rest room flushing points. (3 Echoes Content material Studio)

A home-owner is struggling to get her rest room to flush fully. She says she has to carry the deal with down till the bowl is flushed.

She desires to know, “Why does this occur, and the way can I repair it?”

There are two causes that she could also be having this drawback. One, there may be not sufficient water within the tank, which means the water stops earlier than reaching about half an inch under the overflow tube. That’s the place you wish to regulate it.

Subsequent, you wish to make sure that while you push down the deal with, the flapper stays open to permit the flushing motion after which closes. If the chain is simply too brief or too lengthy, that may stop that from occurring.

Another excuse is an obstruction within the drain. If there may be an obstruction, then you definately received’t get that flushing motion as a result of it’s resisting the water going into it.

It’s probably the primary drawback. It is a quite common repair, and there are many nice restore kits on the market. Do that rapidly so that you received’t waste water!

Though fixing a rest room may not be probably the most glamorous type of residence enchancment, it’s so essential to have a working rest room that may keep in good condition for a very long time.

Additional Studying: Information to All of the Components of a Bathroom Tank


Tips on how to Set up an Underlayment

This image shows a notch trowel applying a grout to a wood floor.
Ensure you use the correct notch trowel dimension to put in an underlayment. (3 Echoes Content material Studio)

A home-owner desires to place a quarter-inch underlayment over a tile flooring.

He asks, “Do I have to nail or screw it? What do I take advantage of?”

No, you aren’t going to wish to nail by means of or screw it. You’ll have to glue it down. Do a little analysis and discover the correct adhesive you want, relying on the supplies you might be utilizing. More than likely, it is going to be in a bucket, and also you’ll use a notch trowel to put in the correct amount.

Just remember to learn the instructions to make sure you use the really helpful notch trowel dimension. Lots of people don’t notice that the scale of the notch trowel must correlate with the adhesive with the intention to work effectively.

To make sure there is no such thing as a motion when placing down the ground, use leftover blocks, bricks, or heavy objects to weigh it down a bit bit. Depart it in a single day so that it’s going to dry and actually treatment effectively.

There are a number of choices for underlayment. One choice is a self-leveling underlayment. That is like actually skinny concrete. Do a skinny coat over the tile to create a clean and flat floor for a vinyl flooring to be put over.

Additional Studying: Gluing vs. Nailing Hardwood Flooring


Finest New Merchandise

The StyleWell Parker Mill 4-Piece Steel Patio Set is sturdy and long-lasting, offering you with the out of doors furnishings you’ll be able to depend on. Study extra>>

Easy Options

This image shows a push broom cleaning a tile floor.
Use a push broom earlier than portray to take away mud and grime from partitions. (®JodiJacobson by way of Canva)

Push Broom Paint Prep—Previous to portray a room, it’s essential to wash the partitions and ceiling to take away all mud, grime, and cobwebs. Right here’s a fast and simple approach to do this: Wrap a towel across the head of a push broom, and safe it with a binder clip or pinch clamp. Then evenly mist the towel with water. Now use the towel-wrapped broom to wipe down the partitions and ceiling. The damp towel will lure any mud or grime, abandoning a clear, ready-to-paint floor. This tip additionally works nice to take away joint-compound mud from newly sanded drywall joints.

This image shows a person gluing concrete blocks together.
Use concrete blocks to create simple storage on your gardening instruments. (3 Echoes Content material Studio)

Straightforward-Entry Backyard-Software Storage—Most individuals retailer their garden and backyard instruments within the storage or shed by merely standing them up and leaning them within the nook. There’s nothing significantly improper with this besides that it’s a bit messy, and it’s exhausting to seize one software with out knocking over one other. So, right here’s a brilliant easy answer to that drawback: Take three concrete blocks and stack them up wherever you wish to retailer your instruments. What you find yourself with is 2 deep compartments for storing long-handled instruments. The blocks are heavy sufficient that you just don’t have to fret about them falling over, regardless of what number of instruments you set in there. In case you don’t have sufficient headroom, you should utilize two blocks so you’ll be able to elevate the instruments out. This will provide you with a neat place the place your instruments are out of the best way and simply accessible, and also you don’t have to fret about them falling over.


Additional Studying